Floor Types

Can You Use a Floor Scrubber on a Synthetic or Vinyl Sports Floor?

Can you use a floor scrubber on Taraflex, Omnisports, Pulastic or Mondo sports floors? Yes. The brush speed, pad color, cleaner pH and finish rules from six maker care guides, side by side.

Key takeaways

  • Yes. Every sports floor maker document we read names a scrubber or scrubber dryer as the way to wet clean the floor: Gerflor, Tarkett Omnisports, Sika Pulastic, Mondo and Aacer.
  • Speed is the rule that differs most. Sika caps Pulastic at 150 rpm, Mondo says under 300 rpm for disc scrubbers, and Gerflor allows up to 350 rpm. The walk-behind discs we checked turn at 155 to 285 rpm, so none of them meets Sika's limit.
  • Soft brush or a mild pad only. Tarkett asks for white brushes or white pads, Mondo Vinylsport a soft nylon brush, Sika and Gerflor a red pad. Mondo and Aacer ban black and brown pads.
  • Use a neutral cleaner day to day (pH 7 to 9 for Tarkett and Mondo). Gerflor allows an alkaline deep clean up to pH 11; Mondo says never above 12.
  • No floor finish. Gerflor says finish is "not recommended," Aacer says MP Sport "should not be waxed," and Mondo says no waxes are needed. Wait 30 days before scrubbing over newly painted lines on Mondo floors.

Yes. Every sports floor maker document we read names a scrubber as the way to wet clean the floor. Mondo's Vinylsport guide says a floor scrubber "generally provides much better results than mopping." Sika says Pulastic should be wet cleaned "at least once a week using a scrubber dryer fitted with red pads." The conditions are low speed, a soft brush or mild pad, a neutral cleaner and no floor finish. The speed limit is where the makers differ most. Sika caps Pulastic at 150 rpm, Mondo at under 300 rpm for disc scrubbers, and Gerflor at 350 rpm.

What counts as a synthetic sports floor

A synthetic sports floor is an indoor court or gym floor made from man-made materials instead of maple. It comes in three main kinds:

  • Sheet vinyl with a cushioned back, laid in rolls. Gerflor's Taraflex, Tarkett's Omnisports and Mondo's Vinylsport are this type. Mondo describes Vinylsport as "resilient vinyl flooring with a compressible foam backing."
  • Rubber sheet or tile. Mondo's indoor athletic floors (such as Advance, Ramflex and Sport Impact) and Aacer's MP Sport are rubber.
  • Poured floors, mixed and laid on site as a seamless coating. Sika's Pulastic is this type. Sika's guide refers to "the sports floor coating."

Two terms decide the answer. Rpm is revolutions per minute: how fast the brush or pad spins. Each scrubber's spec sheet prints it. Pad color is the floor trade's code for how aggressive a pad is. White and red are the mildest. Blue and green cut harder. Brown and black are made to strip floor finish. Our brushes and pads guide sets out the full scale.

Why two answers circulate

One answer is "never scrub a gym floor." It comes from wood. The Maple Flooring Manufacturers Association says it "does not recommend the use of automated power scrubbing equipment" on maple. Our wood gym floor guide covers that. People hear it and apply it to every gym.

The other answer is a flat yes. One parts dealer's page opens with "a resounding yes." It goes on to advise soft brushes and a neutral cleaner, and to follow the floor maker. But it gives no speed limit, and speed is the rule that varies most from maker to maker.

The makers settle it. Synthetic floors are meant to be scrubbed, and their care guides say so. But each sets limits, and the limits are tighter than a normal scrubber setup. A red pad at 230 rpm is fine on one floor and outside the rules on another.

What six care guides allow

We read the current or latest care document from each maker and copied the machine, pad, speed and chemical rules as written.

DocumentBrush or padSpeed limitRoutine cleanerStrongest cleaning allowedFloor finish
Gerflor, Maintenance Instructions for Sport Products (USA, 2015)3M 5000 or 5100 daily; 3M 5100 for regular and deep cleansMax 350 rpm, rotary or cylindricalNeutral cleaner, or clean waterAlkaline cleaner pH 8 to 11, about 5 minutes dwell, then rinse. Never above pH 11"Not required and not recommended"
Tarkett, Omnisports Vinyl Maintenance Guide (November 2016)White soft brushes or white pads; nylon brushes or red pad for periodic careNone statedpH 7 to 9 floor cleaner at 1%Tanex Trophy at 10%, left 5 minutes, then vacuumedNot stated
Sika, Pulastic cleaning adviceRed pad. Green or blue pad for persistent stains "may affect the top layer"No more than 150 rpmPulastic Eco Clean 1:200, at least weeklyPulastic Deep Clean 1:10, twice a year, from 6 months old, then rinseNot stated
Mondo, Vinylsport maintenance (R120320)Soft nylon brush only. No black, brown or other abrasive padsUnder 300 rpm for disc scrubbers, low down pressureNeutral, pH 7 to 9Heavy duty cleaner, rarely a stripper. Never above pH 12 or below 2"No waxes or special coatings needed"
Mondo, indoor rubber athletic flooring (R100219)Red pad or soft nylon brush; green pad or brush for first and deep cleansUnder 300 rpm for disc scrubbers, low pad pressureNeutral, pH 7 to 9Degreaser, heavy duty cleaner or stripper may be prescribed. Avoid above pH 12 or below 2"No waxes or special coatings needed"
Aacer, MP Sport care and maintenanceSoft brushes or a red buffing pad. No green, brown or black padsNone statedAacer CourtKleen, a neutral cleaner, in hot waterSame cleaner, left about 5 minutes, rinsed several times"Should not be waxed"

Gerflor's sheet covers its sport products in general and does not name a range. Applying it to Taraflex, Gerflor's best-known sports vinyl, is our reading. We found no Taraflex-only care sheet. Gerflor's 3M 5100 is the red buffer pad that Forbo's guide also names, as our linoleum guide shows.

The speed limit, against real machines

Speed is the rule most crews miss, because they never change it. A disc scrubber spins at one fixed rate. Our asbestos floor tile guide collected brush speeds from spec sheets. Here are the disc heads, set against the three limits.

Machine (disc head)Spec sheet speedGerflor, 350 rpmMondo, under 300 rpmSika Pulastic, 150 rpm
Nilfisk SC500155 rpmYesYesNo, by 5 rpm
Minuteman E17 to E30180 rpmYesYesNo
Tennant T300, 17 and 20 in230 rpmYesYesNo
Tennant T300, 24 in285 rpmYesYesNo

Every disc in that table meets Gerflor and Mondo. None meets Sika. On Pulastic, you need a machine whose own sheet prints 150 rpm or less, or Sika's written approval for the one you have.

Fast heads are a separate case. Gerflor names cylindrical machines, but its 350 rpm cap still applies to them. The cylindrical brushes in that same table turn at 600 to 1,500 rpm, which is well past it. Mondo's limit is written for disc scrubbers and says nothing about cylindrical speed. Our disc vs cylindrical guide explains why rollers spin so much faster.

Worked example: one scrubber, three gym floors

Take a school district that owns a Tennant T300 with a 20 in disc head. Its spec sheet prints 230 rpm. The district has three gyms. Walk the machine through each one.

  1. A Mondo Vinylsport gym. 230 rpm is under Mondo's 300. The red pad the crew uses in the halls must come off. Mondo wants a soft nylon brush on Vinylsport, with down pressure set to "low." Wet the floor, let the cleaner sit 5 to 10 minutes, scrub in more than one direction, and pick up the water.
  2. A Gerflor gym. 230 rpm is under Gerflor's 350. A 3M 5100 pad is allowed. Every two to three months, Gerflor's deep clean applies an alkaline cleaner of pH 8 to 11 with the vacuum off. Leave it about 5 minutes, scrub again with the vacuum on, then rinse.
  3. A Pulastic gym. 230 rpm is 80 rpm over Sika's limit of 150. The pad is right, since Sika asks for red, but the machine is not. Sika says scrubber dryers "must be adjusted to low speed (no more than 150 revs per minute)." This machine is outside Sika's advice before the first pass.

Now change one fact. Suppose the third gym were Mondo rubber instead. The same 230 rpm machine fits, and a red pad is allowed for regular washes. The floor type, not the machine, decided each answer.

Chemicals and finish

Day to day, every guide asks for a neutral cleaner. Tarkett and Mondo both give pH 7 to 9. Mondo wants a cleaner that is "low foaming and film-free." Aacer calls CourtKleen "neutral." Our neutral cleaners guide covers what that word means on a label.

Deep cleans differ. Gerflor allows up to pH 11 and says never higher. Mondo sets the outer line at pH 12 and pH 2. Sika uses its own Deep Clean at 1:10 and says other products fall outside its liability. Every deep clean ends with a rinse. Sika says the rinse "should never be skipped." Mondo says several rinses may be needed. Leftover cleaner leaves a film that traps dirt. Our residue and rinsing guide explains how to check for it.

Keep finish off. Gerflor says a floor finish is "not required and not recommended." Aacer says MP Sport "should not be waxed" because waxing "can also cause the surface to become slippery." Mondo says "no waxes or special coatings needed." Mondo does list an optional rejuvenator, a cleaner that leaves a thin protective film, but that is not a floor finish. Tarkett's Omnisports comes with a factory polyurethane treatment called Topclean XP.

Timing and rubber floors

New floors need a wait. Mondo says the first wash should wait at least 72 hours after install. Sika says the first clean of Pulastic must be "at least five days after the sports floor coating is applied," and done with a scrubber dryer. Game lines need longer. Mondo says to wait at least 30 days before scrubbing over newly painted lines. Our guide to how long to wait after installing vinyl covers other floor types.

Rubber needs water under the pad. Mondo says rubber "can be 'grabby'" and a wet surface "is essential for the scrubber to move freely" and to avoid friction burns. Do not let the floor dry before you scrub. Our rubber flooring guide covers rubber in weight rooms and halls.

How to scrub a synthetic sports floor

  1. Find the maker's care sheet for your exact floor. The installer or the school's building file should have it.
  2. Check your machine's brush speed on its spec sheet. Compare it with the maker's limit.
  3. Dust mop or vacuum first. Sika and Mondo both start with dry cleaning.
  4. Fit the brush or pad the maker names. Never use black or brown pads.
  5. Set down pressure to low, as Mondo asks.
  6. Mix a neutral cleaner at the label rate.
  7. Scrub and pick up the water. Follow the maker on dwell time. Sika's routine clean picks the water up at once. Mondo lets the cleaner sit 5 to 10 minutes first.
  8. Rinse after any deep clean, and let the floor dry fully before play.

For a school's wider floor plan, see our schools and universities guide. For clubs, see gyms and fitness.

What this answer does not cover

This page covers indoor sheet vinyl, rubber and poured sports floors from the makers named above. It does not cover maple or other wood courts. We found no care sheet from Connor or Robbins for their synthetic floors, so ask yours. Gerflor's sheet is general, and we read it as covering Taraflex. If your Taraflex came with its own guide, that guide wins. Outdoor courts and artificial turf are not covered. Acrylic-coated and plastic tile courts have their own makers and rules; see our indoor pickleball court guide. Sika asks you to contact it if your floor sees handball resin or gymnastics chalk (magnesium). The warranty is the real limit. Tarkett "will decline all potential damages" after the wrong procedure, and Sika excludes damage from other pads and cleaners. Check your floor's warranty before you change pads, speed or chemicals.

Frequently asked questions

Can you use a floor scrubber on Taraflex?

Yes. Gerflor's sport floor sheet names an auto scrubber, rotary or cylindrical, at no more than 350 rpm, with a 3M 5000 or 5100 pad and a neutral cleaner. It does not name Taraflex by range, so check your floor's own guide.

What rpm should a scrubber run on a sports floor?

It depends on the maker. Sika caps Pulastic at 150 rpm, Mondo says under 300 rpm for disc scrubbers, and Gerflor allows up to 350 rpm. Tarkett and Aacer give no figure.

What pad do you use on a vinyl sports floor?

A mild one. Tarkett asks for white brushes or white pads on Omnisports. Mondo wants a soft nylon brush on Vinylsport. Gerflor and Sika name a red pad. Mondo and Aacer ban brown and black pads.

Should you wax a synthetic gym floor?

No. Gerflor says finish is not recommended, Aacer says MP Sport should not be waxed, and Mondo says no waxes are needed.

How long after painting game lines can you scrub?

Mondo says to wait at least 30 days before using a floor scrubber over newly painted lines, and to follow the paint maker's cure time.

Sources

  • Gerflor USA, Maintenance Instructions for Sport Products (2015): dp-assets-new.s3.amazonaws.com
  • Tarkett Sports, Omnisports Vinyl Maintenance Guide (November 2016): tarkett.com.br
  • Sika Nederland, Cleaning Advice: Pulastic Sports Flooring, via Sika New Zealand: nzl.sika.com
  • Mondo, Vinylsport Resilient Athletic Flooring Maintenance (R120320), via CRG: crg.us.com
  • Mondo, Indoor Resilient Athletic Flooring Maintenance (R100219), via Kiefer USA: kieferusa.com
  • Aacer Flooring, MP Sport Care and Maintenance: aacerflooring.com
  • Tennant, T300 specifications, North America (Rev 10-23): tennantco.com
  • Nilfisk, SC500 brochure (Spanish edition): nilfisk.com
  • Minuteman, E Series specifications (E17 to E30), via WebstaurantStore: webstaurantstore.com
  • Cleaning Parts Direct, Can You Use a Floor Scrubber on a Gym Floor? (March 8, 2024): cleaningpartsdirect.com